NoxCar
Tax CalcFind My Car

MaintenanceEngine Oil GuideDatsun GO

Best Engine Oil for Datsun GO in Pakistan

Exact oil grade, capacity, change interval, and best brands available in Pakistan for the Datsun GO.

Datsun GO Engine Oil Specifications

Recommended Grade
10W-30
Oil Capacity
3
Change Interval
5000
API Rating
SN / SP
Best Engine Oil Brands for Datsun GO in Pakistan
★ TOP PICKTotal|Caltex|Shell

Standard mineral or semi-synthetic.

How to Change Engine Oil on Datsun GO — Step by Step

1
Warm up the engine
Run engine for 2–3 minutes. Warm oil flows out faster and carries more contaminants. Do not run at full temperature.
2
Drain old oil
Remove drain plug under the car. Let oil drain fully into a pan. Replace drain plug with new washer. Torque to 25–30 Nm.
3
Replace oil filter
Use an oil filter wrench to remove the old filter. Apply a thin film of new oil to the new filter gasket before installing. Tighten by hand + 3/4 turn.
4
Add new oil
Pour 3 of 10W-30 through the filler cap on top of the engine. Use a funnel to avoid spills.
5
Check level
Start engine for 30 seconds, switch off, wait 2 minutes, check dipstick. Level should be between MIN and MAX. Add more if needed.
6
Record the service
Note odometer reading and date in your service book. Set a reminder for the next change interval.

Engine Oil Change Cost for Datsun GO in Pakistan

DIY Cost (oil + filter)
Rs. 3,000–5,500
Oil + filter from market, no labour
Workshop Cost
Rs. 4,000–8,000
Oil + filter + Rs. 500–1,500 labour
Authorized Service
Rs. 5,500–10,000
Dealer service centre — genuine parts guaranteed

Datsun GO Engine Oil FAQs

What engine oil should I use for Datsun GO in Pakistan?

The Datsun GO requires 10W-30. The best brands available in Pakistan are Total|Caltex|Shell. Oil capacity is 3 and should be changed every 5000.

How often should I change engine oil in Datsun GO in Pakistan?

Change every 5000. In Pakistan's conditions — extreme summer heat (45°C+), dusty roads, and stop-and-go city traffic — it is recommended to use the shorter interval (5,000 km) rather than waiting for the longer one. Heat and dust degrade oil faster than European or Japanese driving conditions.

What is the engine oil capacity of Datsun GO?

The Datsun GO engine oil capacity is 3. Always check the dipstick after adding oil — never overfill above the MAX mark as excess oil can foam and damage the engine.

Can I use 10W-40 instead of 5W-30?

Not recommended for modern engines. 10W-40 is too thick for engines specified for 5W-30, especially in winter cold starts. Stick to 5W-30 full synthetic.

Can I use semi-synthetic 5W-30?

Semi-synthetic is acceptable for some engines but full synthetic is always preferred, especially in Pakistan's extreme summer heat. Full synthetic lasts longer and protects better above 40°C.

Is brand of oil important?

Yes — always use API SN/SP rated oil. Shell Helix, Mobil 1, Castrol EDGE and Caltex Havoline are all trusted in Pakistan. Avoid unbranded or counterfeit oils sold at roadside mechanics.

Datsun GO Full Review All Cars Engine Oil Guide Full Maintenance Guide Fuel Cost Calculator